Skyrc Digital Pitch Gauge Bedienungsanleitung PDF herunterladen (Seite 2)

- 2 -

HOW TO USE

Press “POWER” button for about two seconds to turn on the power. For correct pitch

measurements, DPG-010 digital pitch gauge must be zeroed before being used. Press

“ZERO” button once to zero the gauge. Please refer to the below instruction to understand

how to use DPG-010. After used, Press “POWER” button for about two seconds to turn off.

HOW TO CHANGE BATTERIES

Low battery could contribute to reduced screen brightness and abnormal startup. Please

replace battery should this occurs.

Open the battery compartment by removing the four screws at the back of the pitch gauge

with a philips-head screw driver.

Remove the battery compartment cover.

Insert / replace two CR2032 batteries while observing the correct polarity.

Close the battery compartment and fasten it with the four screws.

Should the pitch gauge display abnormal behavior after accidental shock or impact, proceed

to remove and re-install battery to reset the device.

Manufactured by

SKYRC TECHNOLOGY CO., LTD.

www.skyrc.com

RoHS

7504-0315-01

Place the DPG-010 horizontally

leveled with top of helicopter

frames.

Press “ZERO” to zero the

gauge.

ZERO THE GAUGE

Mount the DPG-010 on main

blade to measure the pitch.

MEASURE THE PITCH

1 2

Keine Kommentare

Skyrc Digital Pitch Gauge Bedienungsanleitung Seite 2